A standard card, a soft sleeve and a rigid top loader do not have the same outside dimensions. If you plan to display a protected card, measure the complete setup you want to place in the holder rather than the card alone.
Measure the enclosure, not just the card
Use a ruler to measure the outside width and height of the sleeve, top loader or slab. Include any lip, rounded edge or protruding part that could affect how it enters a slot.
For a rigid case, check thickness as well. A holder can have enough width and height but still be too narrow for a thicker enclosure.
Write down the three measurements
Record width, height and thickness in one unit, such as millimetres. If you are comparing those numbers with a listing shown in centimetres or inches, convert them before deciding.
Measure more than once and keep the enclosure flat on a table. Avoid pushing or squeezing a card protector to make it appear smaller.
Compare the fit details carefully
Look for the listing’s stated card type and slot dimensions. A sample card in a photo or 3D preview is illustrative; it does not confirm that every sleeve, top loader or graded slab will fit.
If dimensions are not clear, ask the seller to confirm the fit using the exact enclosure measurements. Keep the reply with your order notes so you can refer to it later.
Product previews and sample card artwork are for illustration. Check each listing for the holder’s options and dimensions, and confirm card or protector fit before ordering. The designs are independent and fan-inspired; Custom Card Display is not affiliated with or endorsed by Pokémon, One Piece or their rights holders.
READY TO LOOK AROUND?
Find a display for your collection.
Browse the designs and check dimensions and options on each listing.
